Buick Encore: Bulb Replacement / Taillamps, Turn Signal, Sidemarker, Stoplamps, and Back-Up Lamps
Taillamp Assembly
The vehicle has halogen turn signal lamps
and back-up lamps, LED tail/stoplamps, and
a sidemarker lamp on the taillamp
assembly.
Driver Side

- Remove the cover and screws attaching
the panel to the vehicle interior. Remove
the panel.

- Remove the cover.
Passenger Side

- Remove the storage door.

- Remove the cover.

Driver Side Shown, Passenger Side Similar
- Turn Signal Lamp
- Back-Up Lamp
- Remove the bulb holder.
- Remove and replace the bulb.
- Put the bulb holder into the taillamp assembly and tighten.
- Close the covers.
Headlamp Assembly
The vehicle has halogen high-beam and
low-beam headlamps, an LED turn signal
lamp, Daytime Running Lamps (DRL), and a
sidemarker lamp on the headlamp assembly...
To replace one of these bulbs:
Push the left end of the lamp assembly
toward the right.
Turn the lamp assembly down to
remove it.
Turn the bulb socket (1) counterclockwise
to remove it from the lamp assembly (3)...
Other information:
Vehicles may have an engine heater. The
engine heater can help in cold weather
conditions at or below −18 °C (0 °F) for easier
starting and better fuel economy during
engine warm-up. Plug in the heater at least
four hours before starting the vehicle...
Caution
To avoid damage to the steering system,
do not drive over curbs, parking barriers,
or similar objects at speeds greater than
3 km/h (1 mph). Use care when driving
over other objects such as lane dividers
and speed bumps. Damage caused by
misuse of the vehicle is not covered by
the vehicle warranty...