Buick Encore: Windshield Wiper/Washer / Rainsense™
If equipped with Rainsense, a sensor near
the top center of the windshield detects the
amount of water on the windshield and
controls the frequency of the windshield
wiper.
Keep the sensor free from debris to allow
for best system performance.
INT : When enabled, move the windshield
wiper lever to INT. Turn the
INT
band
on the wiper lever to adjust the sensitivity.

- Turn the band up for more sensitivity to
moisture.
- Turn the band down for less sensitivity to
moisture.
- Move the windshield wiper lever out of
the INT position to deactivate Rainsense.
If the ignition is turned off while the wipers
are on LO, HI, or INT, they will
immediately stop.
If the windshield wiper lever is then moved
to OFF before the driver door is opened or
within 10 minutes, the wipers will restart
and move to the base of the windshield...
When using an automatic car wash, move
the windshield wiper lever to OFF. This
disables the automatic Rainsense windshield
wipers and/or manual windshield wipers...
Other information:
This light should come on briefly when the
vehicle is turned on. If it does not come on
then, have it fixed so it will be ready to
warn you if there is a problem.
When the vehicle is on, the brake system
warning light also comes on when the
parking brake is set...
This vehicle was not originally equipped
with winter tires. Winter tires are designed
for increased traction on snow and
ice-covered roads. Consider installing winter
tires on the vehicle if frequent driving on ice
or snow covered roads is expected...
Categories
The rear door safety locks prevent
passengers from opening the rear doors
from inside the vehicle.
Manual Safety Locks

If equipped, the safety lock is located on the
inside edge of the rear doors. To use the
safety lock:
Insert the key into the safety lock slot
and turn it so the slot is in the
horizontal position.
Close the door.
Do the same for the other rear door.
read more